INSTRUCTIONS FOR USE
 

General: KickStrip should be attached one

on each leg, just prior to "lights off", while already

lying in bed. The following instructions refer to a

single leg.

1. Remove KickStrip and green sticker from

    plastic wrapper.

2. Using the alcohol prep (removed from its

    individual wrapper), firmly wipe circular display

    area (see arrow in figure 1).

3. Using both hands, gently peel green sticker from

    its white protective paper and attach sticker firmly

    onto the KickStrip display area, as shown in figure 2.

    A red light will turn on underneath the white

    sensor body, indicating that the sticker is properly

    placed on the display area.

4. The sensor body should be placed on the lower

    front of the leg, just above the joint. The green

    sensor tail should extend to the top center of the

    foot (see figure 3). Remove the three paper

    adhesive covers and attach the device securely

    in place. Stretch foot forward while attaching the tail.

5. To ensure proper placement, note that the tail

    forms two small "waves" when the foot is relaxed

    or contracts upwards(see figure 4). The red light should

    blink with each foot movement, indicating good placement.

    These blinks will stop after about 20 minutes.

6. Repeat sections 1-4 for other leg.

7. Have a good night!

8. Upon awakening, KickStrip should be removed

    from legs, and the tails cut off with scissors (at any

    point along the tail). Note that the red light turns

    ON after the tail is cut off.

8. Return KickStrip to your physician for interpretation

   of the results.